© 2007 ITW Finishing Systems and Products
9
E
5.16. Re-assemble spray head and knob (36). See step 5
6.
Connectors (31), remove connector and clean threads in the gun body. Apply a medium
strength thread locking/sealing compound to the new connector’s thread and screw into gun
body, do not over tighten leave approximately 2mm of thread visible above the gun body face.
Recommended torque 17–18Nm (150–160lbf in).
ACCESSORIES
TEST CAP and GAUGE KIT: Order KK-4559
add cap N° Example: KK-4559-
18
to check atomizing
pressure remove cap and fit test cap and gauge.
SERVICE KIT : Order KK-4566
add fluid tip size required Example KK-4566-
FFH
. Parts marked with *
are included in the kit..
GUN MOUNTING STUD KIT: Order Nr. KK-4573.
TOOL KIT: Order AGG-412.
Comprising 4mm hexagon key for (7,
15, 11). Key Wrench for (21). Pin spanner for (35). 1.5mm; hexagon
key for (37).
EXTRACTOR TOOL: Order J-24728
for (26).
PISTON ASSEMBLY FIXTURE: Order J-24708,
for seal (29) replacement.
REMOTE ‘FAN’ CONTROL ADAPTOR Order AGG-7
5.
For an independently regulated fan air supply, remove ‘FAN’ valve (D) and fit adaptor.
NOTE :
It is possible to exceed 0,7 bar (10lbf/in²) at the air cap with the use of this adaptor.
