E-3
13. Move the machine and paper feed cabinet to the
installation site. Then, adjust the two adjusters
on the front side and the adjuster on the left rear
side to let the paper feed cabinet sit on the floor.
14. Install the supplied fixing legs (two pieces) at two
locations in the front shown in the illustration.
Tighten the screw into the hole A’s to install the
fixing leg. (Eight supplied screws)
Note:
• If you install the finisher (FS-527) immediately
after the installation of the paper feed cabinet,
do not install the fixing leg or fixing leg cover A
at the left front side.
• If the screw cannot be tightened into the hole
A’s because the machine is installed on cush-
ioned floor such as a carpet, use the hole B’s.
15. Install the supplied fixing leg cover A’s (two
pieces), following the steps below.
(1) While slightly pushing the left end of the fixing
leg cover A outward to get it stretched, put the
fixing leg cover on the fixing leg.
Note:
Make sure that the protruded portion shown in the
illustration is outside the fixing leg plate.
(2) Push the fixing leg cover A in the direction of
the arrow to install it.
Note:
Make sure that the tab of the protruded portion is
completely inserted into the hole (C).
To reduce the risk of injury due to unsta-
ble equipment, set stabilizers before use.
A1V4IXC019DA
A1V4IXC020DA
➁
➀
➀
➁
➂
➂
B
A
A
B
➃
➃
A1V4IXC021DB
Protrusion
A1V4IXC080DA
C
Protrusion
16. Install the fixing leg at the right rear corner of the
machine. Tighten the screw into the hole A’s to
install the fixing leg. (Four supplied screws)
Note:
If the screw cannot be tightened into the hole A’s
because the machine is installed on cushioned
floor such as a carpet, use the hole B’s.
17. Install the fixing leg cover A (right rear), following
the steps below.
(1) While slightly pushing the left end of the fixing
leg cover A outward to get it stretched, put the
fixing leg cover on the fixing leg.
Note:
Make sure that the protruded portion shown in the
illustration is outside the fixing leg plate.
(2) Push the fixing leg cover A in the direction of
the arrow to install it.
Note:
Make sure that the tab of the protruded portion is
completely inserted into the hole (C).
To reduce the risk of injury due to unsta-
ble equipment, set stabilizers before use.
A1V4IXC022DA
➁
➀
➂
B
A
A
B
➃
A1V4IXC023DB
Protrusion
A1V4IXC081DA
C
Protrusion
