- 11 -
2 - Installation
1
Remove the paper feed cassette completely
.
2
Push the lower panel down until it clicks.
3
Setup the back side feed cassette stop by pushing
the "PUSH" lever (
A
).
Then adjust the lateral paper guides to the paper
format by pushing lever (
B
) located on the left
guide. Adjust the length paper guide to the paper
format by pushing lever (
C
).
4
Take a paper stack, pull the paper off and align it
on a flat surface.
5
Put the paper stack in the feed cassette
(ex: 200 sheets of 80 g/m² paper).
6
Put the feed cassette back in its location.
Cartridge installation
1
Stand in front of the machine.
2
Push the left and right sides of the cover and pull it
towards you at the same time.
3
Unpack the new cartridge. Gently roll the cartridge
5 or 6 times to distribute the toner evenly inside the
cartridge. Thoroughly rolling the cartridge will
assure the maximum copies per cartridge.
4
Insert the cartridge in its slot by pushing it until it
clicks (last move down) as shown on the picture
below.
5
Close the cover.
You can use paper weighing between
60 and 105 g/m2.
PUSH
B
A
C