4
Pictures for illustra
Ɵ
ve purposes
only
IMPORTANT
This section should be read carefully to ensure safe and correct installation of your humidifier.
GENERAL
This manual contains all details necessary for the planning and installation of the ElectroVap RTH-LC humidifier.
In addition commissioning and maintenance details are included.
The manual is intended for use by engineers and properly trained technical personnel. Maintenance, servicing or
repair work must only be carried out by suitable skilled and qualified personnel, the customer must be responsible
for ensuring their suitability.
Any risks or hazards, especially when working from ladders or towers should be identified by a skilled and Health
and Safety representative and effective control measure put in place.
No liability will attach to the Distributor if any damage, injury or accident is attributable to inattentive, inappropriate,
negligent or incorrect operation of the machinery whether or not caused deliberately. Always isolate all electrical
and water supplies before commencing any maintenance.
Every effort has been made to ensure details contained in this manual are correct, however, in view of the wide
range of conditions experienced in air handling systems, the information provided should only be used as a guide.
Please contact your Agent if any doubt.
Correct use
ElectroVap RTH-LC humidifiers are ONLY intended for use with air handling systems or direct air humidification.
ANY OTHER APPLICATION IS NOT CONSIDERED USE FOR THE INTENDED PURPOSE. THE MANUFAC-
TURER CANNOT BE MADE LIABLE FOR ANY DAMAGE RESULTING FROM INCORRECT USE.
Water
ElectroVap RTH humidifiers are designed to be used with mains, demineralized R/O with a minimum conductivity
of 30 µs or softened water. On no account attempt to introduce any other fluid or chemical into the system. Water
supply should not exceed 6.0 bar and installation should comply with local regulations. If the water pressure ex-
ceeds 6.0 bar, a water regulator valve must be used.
Electricity
All work concerned with electrical installation MUST only be performed by skilled and qualified technical person-
nel (eg electrician or technicians with appropriate training). The customer MUST be responsible for ensuring their
suitability. It is the duty of the installer to ensure that suitable sized cables and MCB protection is provided.
Please observe the local regulations concerning the provision of electrical installations.
Warranty
A one year warranty term - cost and labor - is applicable to the parts of the ElectroVap RTH-LC to the exception
of the usual consumable parts provided our recommendations of use & maintenance have been adhered to. Fai-
lure to specify and fit original parts and accessories will invalidate our warranty.
N
OTE
The manufacturer’s policy is one of continuous research and development. He therefore reserves the right to
amend without notice the specifications given in this document.
E
LECTRO
V
AP
RTH-LC
Safety information