Devatec ElectroVap RTH-HC Series, Инструкция по эксплуатации, Страница: 60 / 64

ELECTROVAP
®
RTH-HC
60
6.3 WATER INLET VALVE
Maintenance of the water inlet valve is to be done after the first 50 hours of
operation. Thereafter, twice a year (minimum).
•
Switch the appliance off.
•
Switch off the water supply to the humidifier and unscrew the water
supply hose.
•
Disconnect the cables from the water inlet valve of your humidifier (Item
1).
•
Loosen the clamp and remove the water supply hose. (Item 2)
•
Unscrew the two screws securing the valve (Item 3).
•
Pull out your valve, remove the filter with pliers and remove the coil (Item
4) by prying it off with a screwdriver.
•
Run water through the valve body and over the filter to remove any
particles.
Once all these operations completed, please reassemble the unit, taking care to check the condition of the water
supply hose clamp. You can put your appliance back into service.
Ensure that all the clamps are properly tightened whenever the humidifier is maintained.
6.4 WATER LEVEL DETECTOR
Maintenance of the detector should be done during each tank maintenance.
•
Disconnect the cables of the water level sensor (1).
•
Unscrew the clamp of the pressure balancing tube (2) and disconnect it
from the cover.
•
To release the sensor, unscrew the hose clamp (3) and disconnect the hose.
Caution, there may still be water inside the tube.
•
Clean the hose without unscrewing it.
•
Unscrew the 3 screws (4) in order to clean the floats and the body of the
level sensor.
Fig. 6-3. Humidifier water inlet valve
Fig. 6-4. Humidifier water level detector