In order to facilitate the assembling of DB9000RX with the Stereo and RDS
Encoder module we have written these detailed instructions.
The instructions will acquaint you with the assembly of the RDS encoder
module. Please read them carefully before you start.
We have illustrated with a photograph each step of the assembling process. If
you have any doubts, before the beginning of a step refer to these photos to
check the accuracy of the assembly process.
Please note that the device must
NOT
be connected to the electrical network
during the assembly.
Please observe the safety standards.
Basic Assembly Principles
Here are a few tips that would make the assembly of the DB-9000RX
Professional IP Audio Decoder and the Stereo and RDS Encoder Module
quick and easy. By using these principles, you can simplify the process and
save yourself some extra time and effort.
1. When you are having a trouble placing a bolt between two separate pieces,
you can get the bolt holes to line up by gently lifting and slightly gliding one of
the pieces, so that it matches the factory holes perfectly.
2. You can make the assembly process faster by gathering the pieces you
need for each step, prior to starting the step.
3. As a general rule for all bolts and locknuts - turning toward the right will
tighten them, turning toward the left will loosen them.
Tools You Will Need
You will need the following tools to complete the assembly of the DB-9000RX
Professional IP Audio Decoder with the Stereo and RDS Encoder Module. If
you don’t have these tools, you can find them at any hardware or department
store.
• Star shaped screwdriver
№
: PH1 and PH2
• Hex screwdriver
№
5
