65 Aleksandar Stamboliyski Str., 8000 Bourgas, Bulgaria
Tel: +359 56 820027, Fax: +359 56 836700
E-mail: [email protected] ,Web: www.devabroadcast.com
- 35 -
Parameter control state:
Parameter control
state allows specific
parameters
to be set before starting the
bandscan
.
Button assignments:
Left / Right Buttons – cycles through available parameters.
Up / Down Buttons – changes the value of selected parameter.
The
name
and the
value
of the selected
parameter
appears briefly over the data plot.
NOTE:
Upon leaving
Parameter control
state the readout for selected
parameter
will disappear
from the screen. This occurs on
OK
press or after 2 seconds timeout if no button is pressed.
Following is the list and short description of available
parameters
from
Bandscan page
.
Bandscan
: Start / Stop – Used for starting or stopping of the
bandscan process
. Setting the
value of this parameter to “Start” will start the
bandscan process
. During
bandscan
the LED
bargraphs are turned to stylized box-shaped progress indicator. The information for
bandscan
progress
is also shown on right bottom corner of data plot.
After
bandscan
completion the value of the
Bandscan parameter
is set to “Stop” automatically.
Bandscan in progress
Running
bandscan
can be stopped by setting the value of
Bandscan parameter
to “Stop”.
Start Frequency
: – set the
start frequency
of the
bandscan
.
End Frequency
: – set the
end frequency
of the
bandscan
.
Step
:10, 20, 50, 100 kHz – set the
step
increments for the band. Smaller
step
leads to more
“fine”
bandscan
but is slower;
Pressing
SB4
in
Bandscan page
will transition to previous page.
NOTE:
Leaving the page will not stop running
bandscan
. The
bandscan
will continue until it
is finished or the value of
Bandscan parameter
is set to “Stop”.
Содержание DB4005
Страница 5: ...THIS PAGE IS INTENTIONALLY LEFT BLANK ...
