Dettson SUPREME SUP10-M2401A, Инструкции по установке и руководство для владельца

Страница: 3 / 18

3
1.0 SAFETY
1.1 DANGER, WARNING AND CAUTION
The words DANGER , WARNING and CAUTION are used to
identify the levels of seriousness of certain hazards. It is
important that you understand their meaning. You will notice
these words in the manual as follows:
DANGER
Immediate hazards which WILL result in death or
serious bodily and/or material damage.
WARNING
Hazards or unsafe practices which CAN result in death
or serious bodily and /or material damage.
CAUTION
Hazards or unsafe practices which CAN result in minor
bodily and /or material damage.
1.2 IMPORTANT INFORMATION
WARNING
Non-observance of the safety regulations outlined in
this manual will potentially lead to consequences
resulting in death, serious bodily injury and/or property
damage.
WARNING
Installation and repairs performed by unqualified
persons can result in hazards to them and to others.
Installations must conform to local codes or, in the
absence of same, to codes of the country having
jurisdiction.
The information contained in this manual is intended for
use by a qualified technician, familiar with safety
procedures and who is equipped with the proper tools
and test instruments.
Failure to carefully read and follow all instructions in
this manual can result in death, bodily injury and/or
property damage.
a. It is the homeowner’s responsibility to engage a
qualified technician for the installation and
subsequent servicing of this furnace;
b. Do not use this furnace if any part of it was under
water. Call a qualified service technician
immediately to assess the damage and to replace all
critical parts that were in contact with water;
c. Do not store gasoline or any other flammable
substances, such as paper, carton, etc. near the
furnace;
d. Never block or otherwise obstruct the filter and/or
return air openings;
e. Ask the technician installing your furnace to show
and explain to you the following items:
i. The main disconnect switch or circuit breaker;
ii. The air filter and how to change it (check
monthly and clean or replace if necessary);
f. Before calling for service, be sure to have the
information of section 5 of your manual close by in
order to be able to provide the contractor with the
required information, such as the model and serial
numbers of the furnace.
IMPORTANT:
All local and national code requirements
governing the installation of central electric heating
equipment, wiring and the flue connection MUST be
followed. Some of the codes that may apply are:
ANSI/NFPA 70: National Electrical Code
CSA C22.1 or CSA C22.10: Canadian Electrical Code
Only the latest issues of these codes may be used, and are
available from either:
The National Fire Protection Agency
1 Batterymarch Park
Quincy, MA 02269
or
The Canadian Standards Association
178 Rexdale Blvd.
Rexdale, Ontario M9W 1R3
1.3 DANGER OF FREEZING
CAUTION
If your furnace is shut down during the cold weather
season, water pipes may freeze, burst and cause serious
water damage. Turn off the water supply and bleed the
pipes.
If the heater is left unattended during the cold weather
season, take the following precautions:
a. Close the main water valve in the house and purge the
pipes if possible. Open all the faucets in the house;
b. Ask someone to frequently check the house during the
cold weather season to make sure that there is sufficient
heat to prevent the pipes from freezing. Tell this person
to call an emergency number if required.
2.0 INSTALLATION
This furnace is a true multi-position unit, in that it will function
in an upflow, downflow or horizontal configuration to the left
or the right. Only a few modifications are required during
installation to change from one position to another. The unit
is shipped in the upflow configuration and instructions as to
how to change to the other positions are included in this
manual.
The unit requires a
120/240 VAC power supply to the control
panel, thermostat hook-up as shown on the wiring diagram.
The louvers at air supply can be adjusted depending static
pressure or desired airflow or temperature differential.