Dettson CC15-M-V, Инструкции по установке и руководство для владельца

Страница: 17 / 40

B - This terminal is used to pass a reversing valve
signal to a condenser. It is only a holding place for
connecting a wire from the thermostat and a wire from the
condenser. It does not change the airflow of the cool/heat
commands.
7.4 ALTERNATE POWER SUPPLY
Dettson doesn’t recommend to operate the furnace on a
generator or other alternate power supply. If so it must
produce a smooth sinusoidal waveform for compatibility
with the furnace electronics. The alternate power supply
must generate the same voltage, phase, and frequency
(Hz) as shown on the furnace rating plate.
Power from an alternate power supply that is non-
sinusoidal may damage the furnace electronics or cause
erratic operation.
Contact the alternate power supply manufacturer for
specifications and details.
Table 8 – Electrical Data
Unit size Volts-Hertz-Phase Operating Operating Maximum Unit Maximum fuse
range Min range Max unit amp ampacity CKT BRK amp
15,000 120-60-1 127 104 10.7 12.6 15
Table 9 – Thermostat Choice VS System
Heating Cooling Thermostat HRV interlock Interface Smart Duct
system system at low CFM board needed compliant
Modulating Alizé Communicating Yes Yes Yes
chinook R02P032
Modulating 1 stage Non-Alizé Communicating Yes Yes No
chinook Cooling unit R02P032
Modulating 1&2 stage Non-Alizé 2-Stage No No No
chinook Cooling unit/Heat pump R02P032
17