DETROIT GHG17, Быстрый старт, Страница: 4 / 10

17 TS-12Rev - 4 - 12/9/2019
6. Remove the following plastic connector clips. Reference Figure 4.

Two 90-degree elbows

Three T-fittings

21-pin connector fitting

Soot Sensor fitting
Figure 4
– Harness Clip Removal
7. Remove the convoluted tubing using scissors or tool DKI0CHA17002-13 from the Chassis
Terminal Extraction Tool Kit DKI0CHA17002. Take care not to cut the wire harness. DO
NOT USE A RAZOR BLADE. If using the Harness Fiber Tape Wrap Cutting Tool, use the
sharp end to make an incision in the tubing, and then insert the blunt end to cut the tubing.
Reference Figure 5.
Figure 5
– Harness Fiber Tape Wrap Cutting Tool