DSE F501-300 (Rev 06/28/19)
Page 6 of 15
Figure 8
–
Strip Wires for Connector
13.
Remove the nut on the provided LED and insert the LED through the square hole on the
front of the wiper switch LED light box assembly. Install the nut back onto the LED and tighten
with a 8mm wrench (Figure 9).
Figure 9
–
Install LED into Light Box Assembly
14.
Remove the star washer and hex nut from the new wiper switch. Install the wiper switch
through the back of the light box assembly. Make sure the anti-rotation tab on the wiper
switch locks into the anti-rotation hole on the light box assembly (Figure 10).
Figure 10
–
Insert Wiper Switch into Light Box
15.
Install the star washer and hex nut that was removed in the previous step and re-install it
onto the wiper switch. Tighten the wiper switch nut into the light box assembly using a 13mm
