DETEWE M100-AT4, Руководство по установке

Страница: 9 / 16

M100-AT4 Interface Card Installation
7
2. M100-AT4 Interface Card
The M100-AT4 Interface Card allows the OpenCom 100 (OpenCom 130/
OpenCom 131/OpenCom 150(OpenCom X320) to be connected to analogue
trunk lines. The card has four analogue ports; the supported dialling mode is dual-
tone multifrequency (DTMF).
Calling Line Identification Presentation (CLIP) via FSK is supported. Transmission of
call charges data (12kHz or 16kHz pulses) is currently not supported.
Scope of Delivery
■
One M100-AT4 Interface Card
2.1 Installation
The interface card should be installed by qualified personnel only!
For information on installing the OpenCom 100 interface cards please also refer to
the “Mounting and Commissioning” manual.
Proceed as follows:
DANGER! Hazardous voltages inside the device.
1. Switch off the OpenCom 100. Remove the housing cover.
2. Remove the interface card from its transport packaging. Make sure it is the
correct type of card. There is a sticker with the type name on the connector.
CAUTION! Static charge can damage electronic components.
Please observe the regulations regarding electrostatically
sensitive components.