DETEWE M100-AT4, Руководство по установке

Страница: 11 / 16

M100-AT4 Interface Card Configuration
9
Pin outs
The following illustration shows the pin assignment of the M100-AT4 Interface
Card a/b ports.
Connection of an interface card
to pressure terminals (this figure: OpenCom 130)
2.2 Configuration
After you have restarted the OpenCom 100, use the Configurator in the Web
console to configure the M100-AT4 Interface Card. Please also refer to the
OpenCom 100 online help.
Note: Switch to the Configurator ’s Expert mode to obtain
all required dialogues.
Configuring the slot
1. Log in to the Configurator as a user with administrator rights.
Note: In order to configure the M100-AT4 Interface Card, a
firmware version 5.2 or higher is required for an
OpenCom 130/OpenCom 131/OpenCom 150 communica-
tions system. An OpenCom X320 communications system
requires a firmware version 8.5 or higher. If necessary, load
the new firmware via the
SYS Configuration: Firmware
menu. The current firmware version number is displayed in
the
System Info: Versions menu . For an OpenCom 130/
OpenCom 131/OpenCom 150, you should load the most
recent online help version via the
SYS Configuration:
Components menu.
2. Open the PBX Configuration: Ports: Slots menu.
Slot 3
ab 3/1 ab 3/2
ab 3/3 ab 3/4