6
M100-ADSL Interface DSL Modem
Installation Guide
3. Carefully insert the interface card
in slot
no. 3
. The component side
must face to the right. Ensure that
the card is fitted securely.
4. Connect the interface card to the
DSL splitter with the connector
cable supplied. Plug one end of the
cable into the RJ45 socket on the
interface card, and the other end
into the RJ45 socket on the DSL
splitter.
Please note:
In order to reduce the
tension on the RJ45 socket, you should
never lead the connection cable loosely
out of the housing. Always secure the
cable to the housing, e.g. by using the
cable ties supplied to fasten the cable to
one of the recesses or ribs running along
the lower edge of the housing.
5. Close the housing cover. Turn on
the OpenCom 130.
The LEDs on the Interface Card
LED 1 is illuminated for approx.
five seconds after a reset (self test), and
is then extinguished for approx.
ten seconds (system initialisation). The
modem is ready for operation when
LED 1 flashes continuously in 250-ms
cycles).
RJ45 jack
Type (name) of
the interface card
1: LED Ready
2: LED Ethernet Link
3: LED ADSL Showtime
4: LED ADSL Receive
5: LED Ethernet Transfer
1
5
4
3
2
