Detecto WPB Series, Руководство пользователя

Страница: 14 / 24

8525-0380-0M Rev B y WPB Series Owner’s Manual 10
CHECK WEIGHING
The Model WPB Series Waterproof General Bench Scale has a Check Weighing feature that
allows you to set target weights to ensure that the items being weighed are within a specific
acceptable weight range. Check Weighing must be enabled before you can set the upper
and lower limits, and various other functions. Perform the following to enable check weighing:
1. If the scale is not on, press the
ቄ ቄ
key to turn it on. If the scale is on, skip to step 3 .
2. The scale will perform a display test and then change to the weight display.
3. Press the
࿎
key to enable check weighing.
4. The scale display will momentarily show
C6- on
(CHECKING ON), to indicate the
check weighing function has been enabled.
Setting the Upper and Lower Limit Weights
With the scale showing the weight display, press and hold the
࿎
key for three (3) seconds.
The display will change to
set-Hi
(SET HI).
set-Hi
(SET HI) – Set the Upper (Hi) Limit
1. With the display showing
set-Hi
(SET HI), press the
Œ
0
‹
key.
2. The display will change to show the current Upper limit with the first digit flashing.
3. If the current setting is acceptable, press the Œ
0
‹ key to save it and proceed to the
lower limit setting,
set-Lo
(SET Lo).
4. If the current setting is not acceptable, use the Œ T ‹ key to select a new value for the
first digit, and then press the
࿎
key to proceed to the next digit position.
5. Repeat this operation until all digits for the upper limit has been entered, and then
press the
Œ
0
‹ key to save it and proceed to the lower limit setting,
set-Lo
(SET Lo).
set-Lo (SET Lo) – Set the Lower (Lo) Limit
1. With the display showing
set-Lo
(SET Lo), press the
Œ
0
‹
key.
2. The display will change to show the current Lower limit with the first digit flashing.
3. If the current setting is acceptable, press the
Œ
0
‹
key to save it and proceed to
set-Li
(SET Li).
4. If the current setting is not acceptable, use the Œ T ‹ key to select a new value for the
first digit, and then press the
࿎
key to proceed to the next digit position.
5. Repeat this operation until the setting for the lower limit has been entered, and then
press the
Œ
0
‹
key to save it and proceed to
set-Li
(SET Li).