A
A
INSTRUCTION MANUAL
3
Due to the very high intensity of the signal while operating the detector with the 1mX1m
coil or the bigger sized coils, you would not be able to get an idea about the location of
the target and you would have difficulties with its pin-pointing. At the moment you start
hearing a signal from the target press immediately the RESET button, but in no way
while the signal from the target has reached its maximum strength. In this way you’ll be
able to pin-point the target much better. After the resetting, passing over the target you’ll
hear signal with much less intensity (see the right display above) and the pin-pointing will
be much more accurate. We recommend this only to the experienced operators, as there
is a risk to reject a target if resetting the detector in inappropriate moment.
The bigger size of the target, and the closer distance to it, the higher is the intensity of
the signal. When the signal’s intensity is maximal, the graphics will raise to the highest
part of the operative screen, and a value of 100 will be given in the middle of the screen.
If the signal is with a lower intensity (this could happen while resetting, as explained
above) the graphics will reach a lower level, and the value on the screen will be, as in
the described example, 48.
Note: If you are moving the coil correctly, at a constant operational height, not passing
over metal object, and you are not under the influence of strong electromagnetic
disturbances, the graphics will be a smooth straight line “crawling” in the lower end of the
screen, and the intensity of the signal will be 0.
NOTE: While in Automatic Mode the SSP-5100 is a typical motion system - the search
coil should be moved slowly over the ground surface, but never stop over a metal target.
Try to keep constant operational height of the coil. If anyway you change the
operational height of the search coil, nearing it sharply to the ground surface, the
processor will need 7-8 seconds to restore the optimum ticking rate. If you don’t want to
wait for this, you could use whichever of the two RESET buttons for a fast AUTO
retuning.
NOTE: If you RESET while the coil is passing over a metal target the detector will tune
to the target and it will be cancelled, or will produce only a very faint signal.
Some professionals use this feature to decrease the signal’s intensity and receive a
better target pin-pointing. If you have a big shallow target the signal’s line would be like
that on the screen shown left down.
100
48
Содержание SSP-5100 G
Страница 1: ...SSP 5100 G...
Страница 14: ......
