DETAIL K2 POWER OPC503(G), Инструкция по сборке

Страница: 12 / 36

12 | OPC503(G) man.
SAFETY & OPERATION
SAFE PRACTICES & GENERAL INFORMATION
BEFORE TURNING THE KEY AND PULL STARTING ENGINE
• Clear area of all people and property that could be damaged.
• Flying projectiles from operation can cause injury.
• Wear safety glasses, hearing protection, and gloves.
• Do not wear loose fitting clothes that could get stuck in the moving parts of the machine.
• Children should not run this equipment.
• Stay alert of your surroundings and persons that could appear in the area of operation.
THIS UNIT IS DIRECT DRIVE
• There is no clutch to slip or burn up.
• Before starting, make sure all chutes are clear of branches as the cutting wheel will turn as
you pull the recoil starter. Cutter wheel must be free to turn when starting.
PERFORMANCE OPERATION
• Feed larger trees up to 3 inches in diameter slowly into the tubular feed chute, allowing the
cutter wheel to regain speed.
• Forcing a tree into the cutter wheel will stall the machine and damage the cutters or drive
shaft.
• Feed twigs, leaves, and branches up to 1 inch in diameter into the top hopper.
• Wear gloves, as the cutter will grab the branches and pull the into the machine and from
your hands. Never place hands into the top feeder.
• To clear the top feeder, turn the key off, remove it, and unplug the spark plug.
• Be safe, the cutter on this machine is high speed and the blades are very sharp.
SET BOTH OF YOUR WHEEL BRAKE PINS TO STABALIZE MACHINE
DURING OPERATION.
READ AND OBEY ALL WARNING LABELS ON THIS MACHINE
ENGLISH