Desoutter 6151659610, Инструкция по эксплуатации продукта

Страница: 11 / 24

EN Operation
06/2020 11 / 24
Parameter Description
Start torque This is the torque value that must be reached to declare the
Pset as started. Below this value, neither result or report will
be generated.
Angle threshold This is the torque threshold value used to start counting the
angle.
Rundown speed Speed applied from the start to "Downshift torque".
Downshift torque Torque value where the speed moves from "Rundown speed"
to "Downshift speed".
Final speed (or Downshift speed) Speed applied from "Downshift torque" to the motor stop.
Max. time 30 sec by default. The tool stops when the time is reached.
Motor control
Starting at the "Start" signal, the tool runs with a programmed acceleration up to "Rundown speed".
The tool keeps running at "Rundown speed".
Once "Downshift torque" has been reached, the speed changes to "Downshift speed".
Item Parameter Description
1 Pset start torque The Pset start torque is the torque
value that must be reached to declare the
Pset as started.
Below this value, neither result or report
will be generated.
2 Rundown speed Speed applied from the start to "Down-
shift torque".
3 Downshift torque Torque value where the speed moves
from "Rundown speed" to "Downshift
speed".
4 Downshift speed Speed applied from "Downshift torque"
to the motor stop.
Operating Instructions
How to use the tool
How to select the Pset to run
Go to the main screen.
Select the Pset to run.
Press this button during 2 seconds.
Press this button to reach Pset .