122026-01
Rev. A
06/07
DESA Heating, LLC
2701 Industrial Drive
P.O. Box 90004
Bowling Green, KY 42102-9004
www.desatech.com
GAs FIRePlAce INstAllAtION
1. Fireplace should be fully assembled. See
Assembling
Fireplace
in fireplace owner’s manual.
2. Place mantel base close to installation location. See fire-
place owner’s manual for installation clearances. Leave
enough room to insert fireplace from back of mantel.
3. Install gas line. See
Connecting to Gas Supply
in fireplace
owner’s manual. Remember to leave access to the gas
shutoff valve somewhere on the base or where it is ac-
cessible to the user.
4. Check for leaks. See
Checking Gas Connections
in fire-
place owner’s manual.
5. Position fireplace inside mantel (see Figure 6). Carefully
position gas lines. Important: Use caution when position-
ing fireplace on base. Base may scratch easily. Make
sure fireplace is in proper position within mantel opening
before continuing with installation.
6.
Fireplace with louver door:
Lower bottom louver door.
Use two screws provided in hardware package and attach
fireplace to wooden base. Close louver door.
Figure 6 - Installing Fireplace
Fireplace with fixed louver:
Before installing logs or
burner assembly (see owner’s manual) remove screws
securing floor to assembly. Lift floor for access to bot-
tom of fireplace. Use two screws provided in fireplace
hardware package and attach fireplace base to wooden
base. Reinstall floor with screws removed previously.
7. If mantel trim has not yet been assembled, see
As-
sembling Perimeter Trim
. Place metal trim on shoulder
screws. Firmly snap trim assembly over shoulder screws
on fireplace.
8. Carefully push mantel and base into position against
wall.
AssemblING PeRImeteR tRIm
1. Remove packaging from three pieces of metal trim.
2. Locate two adjusting plates with set screws, and two
shims in the hardware packet.
3. Align shim under adjusting plate as shown in Figure 7.
4. Slide one end of adjusting plate/shim in slot on mitered
edge of top trim (see Figure 7).
5. Slide other end of adjusting plate/shim in slot on mitered
edge of side trim (see Figure 7).
6. While firmly holding edges of trim together, tighten both
set screws on the adjusting plate with slotted screw-
driver.
7. Repeat steps 2 through 6 for other corner.
Figure 7 - assembling trim
Side Trim
Slot
Top Trim
Mitered Edge
Shim
Set Screws
Adjusting
Plate
Slot
