www.desatech.com
122026-01A
2
leG Assembly
1. Lay right side panel (#2) face down on a soft surface
to avoid marking finish. Attach three brackets with 1/2"
screws to bottom of right front leg (#3), leaving screws
slightly loose. Face brackets out toward tongued side
(see Figure 1). Place right front leg over right side (#2)
matching groove in leg to tongue on side, as shown in
Figure 1. Align threaded holes with brackets on side. Start
three 1/2" screws through brackets. Align bottom of side
and leg assembly so they are flush with each other. Hold
these pieces securely in alignment while tightening (but
not over tightening) screws.
2. Assemble left side (#4) and left leg (#5) as described in
step 1.
3. Attach 6 brackets to base (#1) at threaded hole locations
using 1/2" screws leaving screws loose. Face brackets
toward outside (see Figure 2).
Figure 1 - right and Left Leg assemblies
Figure 2 - Leg assembly to Base
Figure 3 - attaching Header
Tongue on
Leg Side
Groove in
Leg Front
1/2" Screw
Bracket
1/2" Screw
Bracket
Right
Side/Leg
Assembly
Header (#6)
Base (#1)
Leg Side (#2)
Leg Front (#3)
Header
Assembly
Block (#9)
1
1
/
4
"
Screw
Washer
4. Place right side/leg assembly on base and align threaded
holes with brackets. Start 1/2" screws through brackets
into threaded holes in side/leg assembly. Back of side/
leg assembly should be flush with back of base. Assure
alignment is correct and spaces are at a minimum. Leave
screws slightly loose.
5. Assemble left side/leg assembly to base following step #4.
HeADeR Assembly
1. Start two 1
1
/
4
" screws with washers through header as-
sembly block (#9) into threaded inserts on right side of
mantel. Repeat for left side (see Figure 3).
2. With arrow pointing up, place header (#6) into position on
top of leg assemblies and against header assembly block
(#9) (see Figure 3). Start two 1
1
/
4
" screws with washers
through header assembly blocks (#9) into threaded in-
serts in header. Hold header in proper alignment with leg
assemblies and tighten, leaving screws slightly loose.
