www.desatech.com
113109-01C
1
O
F
F
P
ILO
T
O
N
H
I
L
O
INSTALLING LOGS
CAUTION: Do not remove the
data plates attached to the heater
base assembly. The data plates
contain important warranty and
safety information.
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.
WARNING: After installa-
tion and periodically thereafter,
check to ensure that no flame
comes in contact with any log.
With the heater set to High, check
to see if flame contact any log. If
so, reposition logs according to
the log installation instructions
in this manual. Flames contact-
ing logs will create soot.
It is very important to install the logs exactly as
instructed. Do not modify logs. Only use logs
supplied with fireplace.
vYGF Models Only
1. Place back log #1 on grate to fit as illustrated
in Figure 28. Make sure middle section at
bottom of log set is seated into “U”-shaped
cutout in center of chassis (see Figure 28).
IMPORTANT:
Make sure log does not cover
any burner ports (see Figure 29).
2. Place front log #2 against front grate prongs
as shown in Figure 28.
3. Place crossover log #3 on top of front and back
logs as shown in Figure 28.
4. Install fireplace screen by slipping notches
of fireplace screen over screws on front of
fireplace (see Figure 30).
INSTALLATION
Continued
Figure 28 - Installing Log Set
Figure 29 - Installing Log Set, Top View
Notches
Figure 30 - Installing Fireplace Screen
Screws for
Mounting Screen
Log Set
Chassis
Crossover
Log #3
Burner
Front
Log #
Burner Ports
Back
Log #1
Grate
Prongs
WARNING: You must operate
this fireplace with the fireplace
screen in place. Make sure fire-
place screen is in place before
running fireplace.
