www.desatech.com
119305-01A
5
Optional
Remote
Control
PRODUCT
IDENTIFICaTION
Figure 1 - Log Base Assembly
(VSGF36NRB Shown)
Log Set
Base
Assembly
Front
Burner
Rear
Burner
Top Louver
Assembly
Fireplace
Hood
Bottom Louver
Assembly
Screen
Assembly
Top Outer
Casing
Figure 2 - Fireplace (VSGF36NRB Shown)
UNPaCkING
CAUTION: Do not remove the
data plates attached to the heater
base assembly. The data plates
contain important warranty and
safety information.
1. With utility knife, cut the carton all the way
around above the staples on the bottom tray.
Lift the carton off the heater. Remove packing.
Note:
The hood is located on top of fireplace
in a carton.
2. Locate one screw above top left corner of the
fireplace screen. Remove and discard screw. Lift
fireplace screen up and pull out to remove.
3. Remove protective packaging applied to logs,
log base assembly and fireplace.
4. Check all items for any shipping damage. If
damaged, promptly inform dealer where you
bought fireplace.
PRODUCT FEaTURES
OPERATION
This vent-free fireplace is clean burning. It requires
no outside venting. There is no heat loss out a vent
or up a chimney. Heat is generated by both realistic
flames and glowing embers. When used without the
blower, the fireplace requires no electricity making
it ideal for emergency backup heat.
SAFETY DEvICE
This fireplace has a pilot with an Oxygen Depletion
Sensing (ODS) safety shutoff system. The ODS/
pilot is a required feature for vent-free room heat
-
ers. The ODS/pilot system shuts off the fireplace
if there is not enough fresh air.
PIEZO IGNITION SYSTEM
This fireplace has a piezo ignitor. This system
requires no matches, batteries or other sources to
light fireplace.
OPTIONAL REMOTE CONTROL
ACCESSORY
There are four optional remote controls (not
included) that can be purchased separately for
this log heater:
• wall switch
• wall thermostat
• hand-held ON/OFF remote
• hand-held thermostat remote
See
Accessories
, page 31.
