background image

1

ElEctric FirEplacE HEatEr

Model: SOM979PS-36AFCN

iMpOrtaNt:

 

 

Please note when you open the carton carefully check the unit and make sure there 
are no damages. If you have any problems with the unit, with how the various func-
tions work or with hidden damages or missing parts, please call: 

1-800-459-4409 

(EST) for customer service.  NOTE: DO NOT RETURN UNIT TO THE STORE 

BEFORE CALLING THE TOLL FREE NUMBER.  Do not dispose of your packag-

ing cartons until you are completely satisfied with your new fireplace heater. 

Read all instructions thoroughly before operating your new Electric Fireplace.

 

NOTE:

 Light bulbs may become loose during shipping. If the flame effect is dim or 

does not work, please check that light bulb or bulbs are finger tight in socket. See 
instructions for replacing bulb or bulbs.  

NOTE:

 The electric fireplace heater may emit a slight harmless odor when first 

turned on. This is caused by activating the internal heater components for the first 
time and should not occur again. 

INSTRUCTION MANUAL

attENtiON: 

1.  Find a location for the fireplace heater that is protected from direct sunlight.
2. Do not plug the unit into the power outlet before reading all instructions.

SaVE tHESE iNStrUctiONS FOr FUtUrE USE.

IMPORTANT SAFETY INSTRUCTIONS

WHEN USiNG ElEctrical appliaNcES, BaSic prEcaUtiONS SHOUlD 

alWaYS BE FOllOWED tO rEDUcE tHE riSK OF FirE, ElEctric SHOcK, 

aND iNJUrY tO pErSONS, iNclUDiNG tHE FOllOWiNG:

1) Read all instructions before using this electric fireplace heater.
2) This electric fireplace heater is hot when in use. To avoid burns, do not let bare 

skin touch hot surfaces. The grill directly in front of the heater outlet becomes 
hot during heater operation. Keep combustible materials, such as furniture, pil-
lows, bedding, papers, clothes and curtains at least 3 feet (0.9 m) away from the 
front of the unit and keep them away from the sides and rear. 

3) Extreme caution is necessary when any heater is used by or near children or 

invalids and whenever the fireplace is left operating and unattended. 

4) Always unplug fireplace when not in use.
 5) Do not operate any electric fireplace with a damaged cord or plug or after the 

heater malfunctions, has been dropped or damaged in any manner. 

6) Do not use outdoors. 
7) This electric fireplace heater is not intended for use in bathrooms, laundry 

areas and similar indoor locations. Never locate heater where it may fall into a 
bathtub or other water container. 

8) Do not run cord under carpeting. Do not cover cord with throw rugs, runners or 

similar coverings. Arrange cord away from traffic area and where it will not be 
tripped over. 

9) To disconnect fireplace, turn controls to off, then remove plug from outlet. 
10) Connect to properly grounded outlets only.
11) Do not insert or allow foreign objects to enter any ventilation or exhaust open-

ing as this may cause an electric shock or fire, or damage the heater. 

12) To prevent a possible fire, do not block air intakes or exhaust in any manner. Do 

not use on soft surfaces, like a bed, where openings may become blocked. 

13) A heater has hot and arcing or sparking parts inside. Do not use it in areas 

where gasoline, paint or flammable liquids are used or stored. 

14) Use this fireplace heater only as described in this manual. Any other use not 

recommended by the manufacturer may cause fire, electric shock or injury to 
persons. 

15) Avoid the use of an extension cord because the extension cord may overheat 

and cause a risk of fire. However, if you have to use an extension cord, the cord 
shall be No.14 AWG minimum size and rated not less than 1875 watts.

16) Caution: Do not plug this product into a receptacle controlled by a wall switch 

or dimmer.

17) When storing or transporting the unit and cord, keep in a dry place, free from 

excessive vibration and store so as to avoid damage.

caUtiON:
iF YOU USE tHiS HEatEr iN cONJUNctiON WitH a tHErMal cONtrOl, a 

prOGraM cONtrOllEr, a tiMEr Or aNY OtHEr DEVicE tHat SWitcHES 

tHE HEatEr ON aUtOMaticallY, rEMEMBEr tO OBSErVE all SaFEtY 

WarNiNGS at all tiMES. tHE FirEplacE HEatEr HaS SaFEtY OVErHEat 

prOtEctiON. iF tHE OVErHEat prOtEctiON tripS, SWitcH OFF all 

SWitcH BUttONS aND Wait apprOxiMatElY 5 -10 MiNUtES. it SHOUlD 

rESEt aUtOMaticallY ONcE tHE UNit cOOlS DOWN.

WarNiNG

Procedures and techniques if not carefully followed will result in damage to the 
equipment and will expose the user to the risk of serious injury, illness or death. 
This electric fireplace heater is for use on 120 volts. The cord has a plug as shown 
at A in illustration below. An adapter as shown at C is available for connecting 
three-blade grounding-type plugs to two-slot receptacles. The green grounding 
plug extending from the adapter must be connected to a permanent ground such 
as a properly grounded outlet box. The adapter should not be used if a three-slot 
grounded receptacle is available. 
A 15 AMP circuit is required to operate this heater. If the breaker trips when the 
heater is used then you may need to move the heater to another location or unplug 
other appliances that are on the same circuit. If you require an extension cord use 
one that is rated at 1875 watts. 

SYL

VAN

IA is a registered tr

ademark of OS

RAM SYL

VAN

IA, used under license.

Summary of Contents for SOM979PS-36AFCN

Page 1: ...w rugs runners or similar coverings Arrange cord away from traffic area and where it will not be tripped over 9 To disconnect fireplace turn controls to off then remove plug from outlet 10 Connect to properly grounded outlets only 11 Do not insert or allow foreign objects to enter any ventilation or exhaust open ing as this may cause an electric shock or fire or damage the heater 12 To prevent a p...

Page 2: ... reach you may use an extension cord rated for a minimum of 1875 WATTS Once the fireplace insert has been properly connected to a grounded electrical outlet it is ready to operate OPERATION BY THE CONTROL PANEL The controls are located behind the grill below the front glass and can be accessed by pulling the grill from the top forward and down O I Press this button for main power and flame effect ...

Page 3: ...ole and bottom right corner holes as shown in the diagram Secure the 10 smaller screws into the remaining holes Make sure the screws are in the correct holes and have been tightened Step 5 Plug in the unit REPAIR SET Touch up repair paint 1 Paint directly on the mantel unit if necessary Fig A Fig A REPAIRS If any problems are found with the original parts during mantel assembly such as the panels ...

Page 4: ...l surface Metal and metal painted parts should be cleaned with damp cloth Do not use abrasive cleaners or spray liquids on these surfaces WARRANTY Every electric fireplace heater is tested before it leaves the factory and it is guaran teed for one year If the unit should fail to operate correctly within one year from the date of purchase call customer service at 1 800 459 4409 EST We will at our d...

Reviews: