www.desatech.com
121486-01F
19
OPERATION
Continued
Note: If pilot does not stay lit, contact a
qualified service person or gas supplier
for repairs. Until repairs are made, light
pilot with match. To light pilot with match,
see Manual Lighting Procedure.
9. Keep control knob pressed in for 30 sec-
onds after lighting pilot. After 30 seconds,
release control knob.
• If control knob does not pop out when
released, contact a qualified service
person or gas supplier for repairs.
Note: If pilot goes out, repeat steps 4
through 8.
10. Slightly push in and turn control knob coun-
terclockwise
to the ON position.
11. Press the on/off key on the remote control
to turn on appliance main burner. Wait at
least 5 seconds before setting desired
flame height.
12. Select manual flame height function by
pressing MODE button on remote until
a flame is shown in lower left corner of
display. Use the UP/DOWN arrow button
to set desired flame height (see Figure 32,
page 20).
13. Replace control cover log (see Figure 26,
page 18).
14. To leave pilot lit and shut off burners only,
press the on/off key on remote control
or turn control knob clockwise
to
PILOT position.
CAUTION: Do not try to ad-
just heating levels by using the
equipment shutoff valve.
Note: The pilot flame on natural gas units will
have a slight curve, but flame should be blue
and have no yellow or orange colo
r.
Figure 28 - Pilot (Propane/LP)
Ignitor
Electrode
Pilot Burner
Figure 29 - Pilot (Natural)
Ignitor
Electrode
Pilot Burner
TO TURN OFF GAS
TO APPLIANCE
1. Press on/off key on remote control and
turn control knob clockwise
to the
OFF position (see Figure 27, page 18).
2. Close equipment shutoff valve (see Fig-
ure 18, page 15).
MANUAL LIGHTING
PROCEDURE
1. Follow steps 1 through 7 under
Lighting
Instructions
, page 18.
2. Depress control knob and light pilot with
match.
3. Keep control knob pressed in for 30 seconds
after lighting pilot. After 30 seconds, release
control knob. Now follow steps 9 through 11
under
Lighting Instructions
in column 1.
HAND-HELD
REMOTE OPERATION
BATTERIES
WARNING: Make sure your
selector switch is in OFF posi
-
tion before installing or chang
-
ing batteries in your hand-held
remote or receiver.
For installing or replacing batteries in remote
control or receiver, see
Installing Batteries in
Remote Control and Receiver
on page 12.
Low Battery - Hand-Held Remote Control
When batteries in hand-held remote control
are low, an icon will appear on display (see
Figure 30).
ON
Figure 30 - Low Battery Display
Low Battery - Remote Receiver
When batteries in receiver are low, no acous-
tic signal will be given when ON/OFF button
is pressed. If batteries in receiver are low,
fireplace can be switched on manually by
moving remote selector switch to ON (see
Figure 27, page 18).
