www.desatech.com
121486-01F
17
INSTALLATION
Continued
4. Place right front log (log #4) on peg of log
#3 and grate prongs as shown in Figure
23, page 16.
5. Place left crossover log (log #5) on pegs
of log #2 and #3 (see Figure 24). Place
Figure 24 - Placement of Crossover Logs
(Logs #5, #6, and #7)
Log #5
Log #6
Log #7
Figure 25 - Control Cover Log (Log #8)
Placement
Log #8
OPERATION
middle crossover log (log #6) on pegs of
log #1 and #2 (see Figure 24). Place right
crossover log (log #7) on pegs of log #2
and #4 (see Figure 24).
6. Slide control cover log (log #8) into
place between front logs #3 and #4 (see
Figure 25).
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not fol-
low these instructions exactly,
a fire or explosion may result
causing property damage, per
-
sonal injury or loss of life.
A. This appliance has a pilot which must
be lighted by hand. When lighting the
pilot, follow these instructions exactly.
B. BEFORE LIGHTING smell all around the
appliance area for gas. Be sure to smell
next to the floor because some gas is
heavier than air and will settle on the
floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do
not use any phone in your building.
• Immediately call your gas supplier
from a neighbor’s phone. Follow the
gas supplier’s instructions.
• If you cannot reach your gas supplier,
call the fire department.
C. Use only your hand to push in or turn
the gas control knob. Never use tools.
If the knob will not push in or turn by
hand, don’t try to repair it, call a quali
-
fied service technician or gas supplier.
Force or attempted repair may result in
a fire or explosion.
D. Do not use this appliance if any part
has been under water. Immediately call
a qualified service technician to inspect
the appliance and to replace any part of
the control system and any gas control
which has been under water.
