www.ironhaus.com or www.desatech.com
121333-01A
27
INSTALLING BRICK LINER MODELS
BL36DA(SA) AND BL36DHA(SA)
WARNING: If fireplace has
been running, turn off unit. Let
cool before installing brick liner.
You may purchase brick liner from your local
retailer or see
Accessories
, page 42.
CAUTION: Always handle
brick panels with two hands.
Do not force brick panels into
place. Excessive force will break
brick panels.
1. Remove top and bottom louvers to allow
access to door latches.
2. Unlock door latches and open glass door.
See
Removing Inner Glass Door
, steps 1
and 2, page 26.
3. Carefully remove lava rock and ember
material.
4. Remove andiron assembly from plenum
by removing screws.
5. Carefully lift logs and ember pod from burner
6. Remove screws that attach plenum to
burner to remove plenum.
7. Remove three screws from deflector
shield on the inside top of firebox. Set
shield and screws aside.
8. Install rear brick panel first. Rest bottom
edge of panel on back edge of burner
assembly (see Figure 45).
9. Install left side brick panel by sliding it
between burner assembly and side of
firebox (see Figure 45).
10. Install right brick panel using the same method
described in step 6 for left brick panel.
11. Replace deflector shield using screws
removed in step 7.
12. Using screws removed in step 6, replace
plenum and attach to burner.
13. Carefully replace ember pod and log set.
14. Use screws removed in step 4 to replace
andiron assembly.
15. Install lava rock and glowing embers. See
Installing Lava Rock and Glowing Embers,
page 26.
16. Close glass door and lock latches on top
and bottom of door and replace screen.
See
Removing Inner Glass Door
, steps 5
and 6, page 26.
17. Replace top and bottom louvers.
FIRePLACe INSTALLATIoN
Continued
Figure 45 - Installing Rear Brick Panel
Rear Brick
Panel
Left Side Brick
Panel
oPeRATIoN
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not fol-
low these instructions exactly,
a fire or explosion may result
causing property damage, per
-
sonal injury or loss of life.
A. This appliance is equipped with an igni
-
tion device which automatically lights
the pilot. Do not light pilot by hand.
B. BEFORE LIGHTING smell all around
the appliance area for gas. Be sure to
smell next to the floor because some
gas is heavier than air and will settle
on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do
not use any phone in your building.
• Immediately call your gas supplier
from a neighbor's phone. Follow the
gas supplier's instructions.
