www.desatech.com
118116-01D
11
OPTIONAL GAS LINE INSTALLATION
Continued
CAUTION: All gas piping
and connections must be tested
for leaks after the installation
is completed. After ensuring
that the gas valve is on, apply
soap and water solution to all
connections and joints. Bubbles
forming show a leak. Correct
all leaks at once. DO NOT USE
AN OPEN FLAME FOR LEAK
TESTING AND DO NOT OPER-
ATE ANY APPLIANCE IF A LEAK
IS DETECTED. LEAK TESTING
SHOULD BE DONE BY A QUALI-
FIED SERVICE PERSON.
WARNING: Do not oper-
ate an unvented gas log set in
WKLV¿UHSODFHZLWKWKHFKLPQH\
removed.
If you install a decorative gas appliance
(vented gas log), the decorative gas appliance
BRICK INSTALLATION
Figure 19 - Installing Brick
Brick
Stamped Letter Location
Brick
Housing
Flanges
must comply with the
Standard for Decorative
Gas Appliance for Installation in Solid Fuel
%XUQLQJ)LUHSODFHV$16==RU
5*
and shall also be installed in accor-
dance with the
National Fuel Gas Code, ANSI
=1)3$ODWHVWHGLWLRQ
.
:$51,1* ,I WKH ¿UHSODFH
has been used for wood burning,
WKH¿UHER[DQGFKLPQH\PXVWEH
cleaned of soot, creosote and
DVKHV E\ D TXDOL¿HG FKLPQH\
cleaner. Creosote will ignite if
heavily heated.
WARNING: When using a
decorative vented gas log, the
damper must be removed or
permanently locked in the fully
open position and the glass
doors must be in the fully open
position.
Installation of brick should be
GRQHDIWHUWKH¿UHSODFHLVSODFHG
in a permanent location.
Brick housing panels are already installed in
¿UHER[(DFKKRXVLQJLVVWDPSHGZLWKDOHW
-
WHUIXOOVL]HEULFNVDUHQRWVWDPSHG7KHVH
letters will help identify brick when installing
(see Figure 19). It is important to install these
EULFNVH[DFWO\DVLQVWUXFWHG3UHVVEULFN¿UPO\
into brick housing until it snaps. The groove
line on side of brick will come in contact with
WKH ÀDQJH RQ EULFN KRXVLQJ 7KLV VHFXUHV
brick into housing. Smaller bricks may require
a small portion of furnace cement applied to
back of brick to secure it until grouting has
been completed.
7KHEULFNVDUHSDFNDJHGLQ¿YHVHSDUDWH
boxes. These boxes are labeled by sections
RIWKH¿UHER[
Box #1 - Hearth Panel
Box #2 - Rear Panel, Lower Section
Box #3 - Rear Panel, Upper Section
Box #4 - Right Panel
Box #5 - Left Panel
Install bricks one section at a time starting
with hearth panel followed by the rear panel-
lower section, rear panel - upper section and
then left and right panels. IT IS IMPORTANT
TO INSTALL BRICKS IN SEQUENCE.
PLEASE NOTE, FULL SIZE BRICKS ARE
NOT STAMPED.
