www.desatech.com
120044-01D
17
INSTALLATION
Continued
Figure 20 - Installing Remote Receiver
Push
Button
Clips
Bracket
Battery
Clip
9-Volt Battery
Terminal
Wires
Pad
Figure 21 - Connecting Wires
Control Valve
White Wire
From Receiver
Red Wire From
Receiver
Figure 22 - Installing Battery in Hand-Held
Remote Control Unit
9-Volt
Battery
Battery
Housing
Battery Cover
Terminal
Wires
Remote Control Unit
INSTALLING LOGS
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.
It is very important to install these logs exactly
as instructed. Do not modify logs. Only use
logs supplied with heater.
1. Place bottom log in center of the base as-
sembly as shown in Figure 23.
2. Rest rear log in back corner sections of
base assembly as shown in Figure 23.
Make sure log is completely vertical and
not leaning in toward burner where the
flame will touch the log.
3. Position front log as shown in Figure 23,
making sure the grooves in the bottom of
the log fit over the grate prongs.
Base
Assembly
Figure 23 - Installing Log Set
Bottom
Log
Front Log
Installing Batteries for Remote Receiver
and Hand Held Remote Control
Two 9-volt alkaline batteries (not included)
are required to operate this heater with the
wireless hand-held remote control set. One
battery must be installed in the receiver and
one in the hand-held remote control unit.
Note: Only use alkaline batteries.
Installing 9-Volt Battery in Receiver
1. Locate back of receiver behind receiver
bracket mounted on base assembly.
2. Locate the battery clip mounted on the
back of the receiver (see Figure 20).
3. Slide a 9-volt battery through the clip.
4. Attach the terminal wires to the battery.
Installing 9-Volt Battery (Not Included) in Hand-
Held Remote Control Unit
1. Remove battery cover on back of remote
control unit.
2. Attach terminal wires to the battery. Place
battery into the battery housing.
3. Replace battery cover onto remote control
unit.