Diamond Shield Crystal
Instruction Manual
Page 18
Configure the AutoStart function
The device can be configured to turn on automatically at a
configured time and execute a sequence. There are two separate
auto-start configurations allowing two different sequences at different
time points to be executed automatically. The corresponding
configuration menu can be reached as follows:
1. Select the menu item "configurat." From the main menu and
press the OK button.
2. Select either the menu item "AutoStart1" or "AutoStart2" and
press the OK button.
The configuration menu has the following entries:
The input is done with the arrow keys left and right.
Message: The auto-start function can immediately begin
executing the configured sequence or it may first display a
prompt that is connected with an alarm signal. The input is
done with the arrow keys left and right.
Time: Time of the auto-start feature.
The left and right arrow keys change the hours or minutes.
The OK button switches back and forth between hours and
minutes.
Run every: The auto-start function can be configured so that
it is not carried out every day, but e.g. every other day or
every third day.
The input is done with the arrow keys left and right.
Start: Next day the auto-start should occur. This configura-
tion is only possible, if the auto-start function is not
configured for each successive day.
The input is done with the arrow keys left and right.
Start from: If a chip card is inserted, you can specify whether
the auto-start sequence is on the chip card or whether it is in
internal memory.
The input is done with the arrow keys left and right.
Sequence: The desired sequence can be selected. The input
is done with the arrow keys left and right.
Wobble (maximum up to twice the base frequency, at very high
frequencies possibly a little less)