Gold
Series
Pull out the tubes.
Take the clear, 5-inch, U-shaped tube from the spare parts kit and connect it to the O-rings on the front
of the machine .The tube will look like a horseshoe in the front of the machine.
Turn the vacuum knob all the way to the right so the vacuum is at its highest pressure.
Turn on the machine.
If you see crystals going through the clear tube, turn the machine off.
Remove the clear U-shaped tube.
Replace all connections: pink tube, blue tube, hand-piece and tip.
Turn the machine on.
Occlude the tip 5 to 10 times.
The MegaPeel should now be receiving crystals.
WHAT IF CRYSTALS ARE STILL NOT COMING OUT OF THE
HAND-PIECE? #3
Remove the lid..
Check the pink and blue tubing which you attach the hand-piece to and
see if there is a clog.
If you see a clog, replace the tubing.
If you do not see a clog, disconnect the hand piece.
Use the needle in the spare-parts kit to unclog the holes.
Knock the hand piece forcefully against a hard surface.
If you still do not see crystals in the tube, repeat the process with the short
blue-tube as mentioned in Step #1 on page 25
Unplug the machine.
Lift the top of the machine.
Lift the white crystal container (the smaller of the 2 containers) from the
machine.
To remove the blue tube, push down with your thumb on the small, white
plastic piece located on the crystal container.
Take the short blue tube from the spare parts kit.
