Deprag 347-228U, Руководство по эксплуатации

Страница: 33 / 40

33
Assembly of Exhaust Hose 389653 A
The exhaust hose 389653 A should be installed as follows:
1. Disconnect the screwdriver from air supply.
2. Unscrew the quick release nipple 804273 from the valve housing (right-
hand thread).
3. Remove the silencer 301295.
4. Remove the silencer 323665, located closest to the air-inlet and slide the
left-over silencer over the valve housing, as shown on the spare parts
drawing.
5. Position the connection piece as needed and tighten the quick release
nipple 804273 (max. torque: 5 Nm = 44 in.lbs.).
6. Connect pressure hose with quick release coupling and push the
exhaust hose over the connection piece.
Assembly of Support Ring 389775 A
For better driver support and to allow an increased down-pressure force, the
support ring 389775 A may be installed as follows:
1. Disconnect the screwdriver from air supply.
2. Unscrew complete clutch bearing (left-hand thread).
3. Remove the o-rings 802480 and 828074.
4. Slide the support ring over the clutch bearing according to illustration and
install the o-ring 828074 into the appropriate recess.
5. Tighten the complete clutch bearing with support ring 389775 A to the
screwdriver.
Operating Screwdriver with a Finder:
Installation of the Finder (optional equipment):
·
Remove screw-cap (left-hand thread) from spring sleeve
·
Insert finder and spring into spring sleeve
·
Re-attach screw-cap onto spring sleeve (left-hand thread) and attach
complete spring sleeve package to Screwdriver