- 24 -
(6)
Panel light switch
This is the switch to turn on the panel light
.
(7) Circuit breaker
· 3-phase circuit breaker
This
is
a
main
switch
to
supply
power
to
a
load.
When
the
load
is
shorted
or
in
the
state
of
overload,
it
trips
to
protect
the
generator
against
trouble.
[Note]
Do
not
use
this
circuit
breaker
to
turn
ON/OFF
the
load,
to
prevent
damage
to
the
circuit
breaker.
When
it
trips
with
overcurrent,
the
handle
of
the
breaker stops
between
ON
and
OFF
positions.
This
is
what
is
called
the
trip
condition.
In
this
case,
push
the
handle
down
to
the
OFF
position
to
reset
it,
or
else,
it
cannot
be
set
in
ON
position.
· 1-phase circuit breaker (Option)
It is a circuit breaker for 1-phase output terminal. This
machine is protected by this circuit breaker from over-current
and leakage.
· 1-phase receptacle’s Circuit protector (Option)
Every receptacle on this machine is protected by the circuit
protector from over-current. When the circuit protector tripped,
the white button will extend and push it back in to reset the
circuit protector.
Содержание DCA-150LSKE
