7.
Maintenance
•
Storage and cleaning
If your Electric scooter gets dirty, please clean it with a damp cloth. (you can use a stiff brush first to get the worst dirt off and then
use a cloth afterwards to clean it.). It is also possible to use a little toothpaste if the dirt is stuck. Remember to clean with damp cloth
after this.
Please make sure to keep the Electric scooter turned off while cleaning it, and make sure to cover the charging input to avoid
problems with the electronics.
Please notice:
Do not use alcohol, gas, kerosene or other corrosive and volatile chemical solvents. This can damage both the
appearance and the internal structure of the Electric scooter. You may not use pressured water-gun or running water either.
Please store your Electric scooter in a dry and cool environment when not in use. Avoid leaving it outdoors, as it is not made for use
in wet areas. Nor is it good to expose to high temperatures caused by direct sun for a long time.
•
Maintenance of batteries
Please make sure the batteries do not get over 50° Celsius, or minus 10° Celsius for a longer period of time. (e.g. don’t leave the
Electric scooter in a hot car in summer, do not put batteries into fire et.) Low temperature (e.g. subzero temperature) can damage the
battery cells.
Keep the Electric scooter away from open flame or other sources of heat to prevent the battery from getting too hot. Also make sure
not to leave the Electric scooter at freezing temperatures. Both heat and excessive cold can cause the battery to discharge.
Please avoid draining the batteries 100%. It is best to charge them while there is still power on them. This will extend battery life.
Also if riding the Electric scooter in cold or very hot areas, the battery time can be lower than when riding in temperatures from 15-
25° Celsius. This is not a failure on the batteries, but normal behavior.
Do not overcharge and discharge the battery.
Make sure that the battery is charged at regular intervals, even if you do not use the Electric scooter for a long time. This is to prevent
damage to the battery caused by low voltage over an extended period.
Please notice:
Even fully charged batteries will run out of power if the Electric scooter is not used for a period of time. Expect
between 90 and 120 days in off mode if batteries are fully charged. If only partially charged, this period of time is lower.
Please make sure to charge the batteries before they are 100% out of power, to avoid damaging the battery cells. (damaged battery
caused by wrong handling are not covered by warranty)
It is forbidden to disassemble battery package. This is only to be handled by official service repair centers and professionals.
•
Maintaining bearings
The Electric scooter has sealed and dustproof bearings so that no lubrication is required. Check the bearings for wear at regular
intervals to avoid unsafe riding. Do not jump on and off and do not apply excessive force otherwise to avoid damage to the bearings.
This is not a sports Electric scooter.
•
Maintaining wheels
Check the wheels for wear at regular intervals to avoid unsafe riding.
•
Maintaining the brake
The brake pad is made of metal. Check the brake pad for wear at regular intervals to avoid unsafe riding. Do not apply excessive
force to avoid damage to the brake.
•
Maintaining screws and other fasteners
Make sure that all screws are properly tightened to avoid unsafe situations.
8
