DENTSPLY ProMix 400, Руководство по ремонту

Страница: 9 / 24

5.1 OPERATION
The operation of the ProMix™ can be controlled by the LCD display and the seven (7) push
buttons/pads located on the front panel.
Display Board Indicates the set (desired) amalgamation cycle/run time
and counts down to
“00” in 1 second intervals during
operation.
“Up” arrow Increments the programmed run time in one second
intervals (to a maximum of 30 seconds).
“Down” arrow Decrements the programmed run time in one second
intervals.
“High” (rabbit) Selects the high amalgamation speed (4200 rpm) and the
associated LED indicator.
“Low” (turtle) Selects the low amalgamation speed (3700 rpm) and the
associated LED indicator.
“Start/Stop” (I/O) Initiates and deactivates the amalgamation cycle.
NOTE: The two (2) “memory” locations are set at the factory
to commonly used settings. To change the settings to
suit individual needs see “Setting Memory Locations”
(page 4).
“M1” (Memory #1) Stores and recalls #1 preprogrammed amalgamation
speed and time, even in the “power OFF” condition.
NOTE: The Memory #1 location is factory set
to 15 seconds at Low speed.
“M2” (Memory #2) Stores and recalls #2 preprogrammed amalgamation
speed and time, even in the “power OFF” condition.
NOTE: The Memory #2 location is factory set
to 20 seconds at High speed.
6