4.4 Adjustment of the Amount of Water Supplied (when
water supply is used)
Check the amount of water supplied, and adjust the amount
of water supplied with the water adjustment knob.
4.5 Adjustment of chip air (when water supply is used)
Check the spraying condition, and adjust the amount of
chip air with the chip air adjustment knob. Increasing the
chip air results in a mist state, and decreasing it results in
a straight-line state.
4.6 For Finishing Work
After completion of operation, close the main air cock.
Use of City Water:
Close the main cock of the tap water.
• When tap water is used, the water pres-
sure may differ according to the installation
location, resulting in changes in the amount
of water supplied; therefore, adjustment
should be made in each case.
1.
As the chuck of the Cercon
®
mill handpiece is a pushin
type, set FG instruments of
ø
1.6 mm and push in as shown in
Fig. 12. Push in the instrument of which the end is tapered
by using the designated bur-inserting wrench as shown in
Fig. 13.
2.
When removing the instrument, it can be removed by
turning the chuck release ring in the direction of the arrow
in Fig. 14.
Fig. 13
26
4 Operational Procedures of Control Unit
Fig. 12
5 Operational Procedures of Handpiece
Fig. 14
Fig. 11
Chuck Release Ring
Use of City Water
Use of Water Supply Bottle
Water Mode Select Switch
Содержание DeguDent Cercon mill
