Denso Kheos, Инструкция пользователя

Страница: 17 / 31

Instruction Booklet
17 ENGLISH
KHEOS
EN
- During operation, press ESC for 2 sec. to exit the phase and return to the main menu. In this case you will not be prompted to
print the report (if printer is present).
- Once the cycle has been completed, press ESC for 2 sec. to exit.
- When you exit the operation, you will be prompted to print the report, if the printer is present. Press OK to print or ESC to return
to the main menu.
- All the refrigerant recovered in this operation increments a recovery counter to monitor the life of the filter; when a total of 45 kg
has been reached, a message will appear on the display informing you that the filters need to be replaced. The counter increases
in 5 g steps.
- If an error occurs, the display will show the associated message and give an acoustic signal. To exit, press ESC
- The time available for the operation is 30 min.
The used oil container must always be empty to prevent leaks.
Executing the partial recovery cycle “g to recover””
This function is used to recover a quantity of refrigerant between 10 g and 1000 g in the gaseous state and to quantify it
accurately.
If the quantity of refrigerant is excessive, low pressure can be used to draw and weight the actual grams (+5g) of refrigerant
removed from the car and fed into the cylinder, without any residues in the unit.
- Connect the low pressure pipe to the A/C system
- Open the LP valve.
- Select RECOVERY with the “+
↑ ” and “- ↓ ” buttons.
Press “OK”, the display will read “AUTO”; use the “+ ↑ ” and “- ↓ ” buttons to select only the grams to be recovered. To start the
recovery cycle press OK. During this operation, the display shows the general parameters, and “GasR:” indicates the gas recovered
and the time taken. The recovery phase ends when the amount of “g” entered is reached.
This cycle does not include a used oil discharge phase.
- During operation, press ESC for 2 sec. to exit the phase and return to the main menu. In this case you will not be prompted to
print the report (if printer is present).
- Once the cycle has been completed, press ESC for 2 sec. to exit.
- When you exit the operation, you will be prompted to print the report, if the printer is present. Press OK to print or ESC to return
to the main menu.
- All the refrigerant recovered in this operation increments a recovery counter to monitor the life of the filter; when a total of 45
kg The counter increases in 5 g steps.
- If an error occurs, the display will show the associated message and give an acoustic signal. To exit, press ESC
- The time available for the operation is 30 min
The used oil container must always be empty to prevent leaks.