Denso First Time Fit TPMS Sensor, Инструкции по установке/снятию

Страница: 3 / 16

Fig. 4
3
Installation of TPMS Sensor
1. Insert the new sensor through the valve stem hole making sure the flat side of the
sensor is toward the rim.
2. Using a standard valve stem tool pull the stem straight through the hole until the valve
stem is fully seated. To avoid damage to the sensor and the rim, use a rubber mallet
or block of wood placed between the rim and the tool to make sure the valve is pulled
straight. (see Fig. 4)
TIRE MOUNTING:
1. Set the tire on tire changer after setting rim location so the TPMS sensor is setting in
the location area as shown below. (see Fig. 5)
RIM
TIRE CHANGER MOUNT
RIM
ROTATION
SENSOR LOCATION AREA
(shaded area)
2. Apply tire lubricant on both sides of the tire bead.

CAUTION:
Prevent lubricating the TPMS sensor.
3. Rotate the rim in the direction as shown and attach the lower bead of the tire to the rim.
4. Rotate the rim in the direction as shown and attach the upper bead of the tire to the
rim.
5. Inflate tire to seat upper and lower beads.
6. Check tire balance and adjust if needed.

CAUTION:
If assembled with TPMS sensor outside this area, contact with the tire bead may
damage the sensor.
2. Using a standard tire valve stem tool,
pull the valve stem through the hole
and discard it. Use a rubber mallet or
a block of wood to avoid damage to
the rim. (see Fig. 4)
Fig. 5