13
Pre-Set
: WiRC will output the value you set with the slider
Sensitivity:
Sets the sensitivity type of the
channel. It can be linear to the
control value, or follow an
exponential curve. Negative value of Exponential Factor means
the sensitivity is higher near the center position and lower near
the end position. Positive Exponential Factor means the sensitivity
is lower near the center position and higher near the end
position.
Sensitivity mix / Value mix:
Mixers allow you to set up dependencies between channel output
values. For example, if you want to reduce the steering sensitivity
at higher speeds, you can set up a
Sensitivity
mix with a
negative factor between the ESC and servo channels. When the
ESC output value is high, the negative sensitivity mix reduces the
channel output changes for the same steering joystick
movement.
Value
mixing enables mixing of output values of channels.
Repeat:
Sets the PPM repeat frequency. It can be set for the pair of
channels: 1-2, 3-4, 5-6. Channels 7-8 have a fixed repeat rate of
50Hz.
