ENGLISH
Get
ting Star
ted
Oper
ation
Tr
oubleshooting
Specifications
ENGLISH
Connecting the speaker cables
Signal direction
Audio cable
Connections
Cable indications
Connect using the connection cables shown below.
A
Analog connections (Stereo)
R
L
R
L
B
Speaker connections
Audio signal
IN
OUT
OUT
IN
Speaker cable
RCA pin-plug cable
Speaker connections
Connect speakers to the speaker terminals making
sure that like polarities are matched (
q
with
q
,
w
with
w
).
1. Loosen by turning counter
clockwise.
Either tightly twist or terminate the
core wires.
2. Insert the cable.
3. Tighten by turning
clockwise.
n
Speaker impedance
Use speakers with an impedance of 4 to 16 Ω/
ohms.
q
w
q
w
-
3
B
B
Speakers
NOTE:
• Do not plug in the power supply cord until all connections have been completed.
• When making connections, also refer to the operating instructions of the other components.
• Be sure to connect the left and right channels properly (left with left, right with right).
• Do not bundle power supply cords together with connection cables. Doing so can result in humming
or noise.
NOTE:
When making connections, take care that
none of the strands in the speaker cable
come in contact with adjacent terminals,
other speaker cable strands, or with the rear
panel and screws.
NEVER touch the speaker terminals when
the power is on. Doing so can result in
electric shocks.
Note on speaker impedance
When using speakers with an impedance
below the designated value (for example 3 Ω/
ohms), playing for long periods of time with the
volume high can cause the temperature to rise,
activating the protection circuit.
When this circuit is activated, the output to
the speakers is cut off and the power indicator
blinks. If this happens, unplug the power
cord, wait for the set to cool off and improve
ventilation around the unit. Also check the wiring
of the input cables and the speaker cables. After
doing this, plug the power cord back in and turn
the unit’s power back on.
If the protection circuit is activated again even
though there are no problems with the wiring
or the ventilation around the unit, switch off the
power and contact a DENON service center.
Connections
