ENGLISH
8
5
Hold the counterweight with a
finger so that it does not move,
then turn the stylus pressure
adjustment ring so that the center
line on the back of the tone arm is
at “0”.
6
Turn the counterweight in the direction of the arrow
and set it for the proper stylus pressure for the
cartridge you are using.
✽
When the counterweight is turned, the stylus pressure
adjustment ring also turns. Read the value on the
adjustment ring to set the proper stylus pressure.
7
Turn the anti-skating knob and set it so that the
value of the cartridge’s stylus pressure is lined up
with the reference line.
• This provides the proper anti-
skating force.
ANTI-S
K
A
T
IN
G
0
1
2
3
4
5 6 7
0
0.5
1
1.5
3
3.5
(continued)
4
CONNECTIONS
• Be sure to turn off the amplifier’s (or mixer’s) power when making
connections.
AC IN
REMOTE
PHONO OUT
SIGNAL
GND
R
L
R
L
R
L
Amplifier
Power outlet
1
Connect the left (white) and right (red) plugs of the
pin-plug cord to the set’s left and right outputs
(PHONO OUT).
2
Connect the ground wire (provided on the pin-plug
cord) to the set’s ground terminal (SIGNAL GND).
3
Connect the left (white) and right (red) plugs of the
pin-plug cord to the amplifier’s (or mixer’s) left and
right phono inputs.
4
Connect the ground wire (provided on the pin-plug
cord) to the amplifier’s (or mixer’s) ground terminal
(SIGNAL GND).
5
Connect the connector side of the power cord to the
set’s power connector terminal (AC IN).
6
Plug the power cord into an appropriate power
outlet.
• Check that the power outlet’s capacity is sufficient.
5
OPERATION
(1) Playing records
z
Starting playback
1
Turn the power dial to turn on.
• The speed button’s LED, the pitch ON button’s LED
and the strobe-illuminator light up.
2
Turn on the amplifier’s (or mixer’s) power and set the
input to “PHONO”.
3
Set a record on the platter.
✽
To play 45 rpm records, use the included adaptor.
4
Set the speed button’s according to the record’s
playing speed.
5
Press the START/STOP button.
✽
The platter starts turning at the speed set in step 4.
6
Lift the lifter lever, hold the head shell’s finger sup-
port, and move the tone arm to the desired position
over the record.
7
Lower the lifter lever.
• The tone arm lowers gently until the stylus is on the
record and playback begins.
8
Adjust the speed of rotation.
• When the PITCH ON button’s LED is lit, the speed of
rotation can be adjusted in a range of ±12% by moving
the pitch slider.
• The speed is lower than the displayed speed when the
strobe is flowing to the right, higher than the displayed
speed when the strobe is flowing to the left. When
the strobe is stopped, the platter is turning at the
displayed speed.
