ENGLISH
7
!5
Tone arm height adjust (HEIGHT ADJUST)
• This allows the tone arm to be properly align with the platter
surface.
!6
Height lock lever (LOCK)
• Prevents accidental adjustment of the height.
!7
Stylus pressure adjustment ring
• Use this to adjust the stylus pressure.
!8
Counterweight
• Use this to balance the tone arm and to adjust the stylus
pressure.
!9
Tone arm lift
• This elevates the tone arm above the record surface.
@0
Extra stylus holder
• Place extra headshells here.
@1
45 rpm adaptor holder
• Place on the attached 45 rpm adaptor here.
• Push down the rear side of 45 rpm adaptor to take it.
@2
Voltage selector
• Check the voltage selector switch is set to an
appropriate voltage in your area before use.
@3
Dust cover
• Set the dust cover in place when not using the set to protect
the turntable from dust and dirt.
• The dust cover is not locked on the set. Handle it with care.
@4
Remote terminal (REMOTE)
• Playback and stopping can be controlled externally using a
control switch.
• No special control switch is provided. Use a control switch
satisfying the conditions described below:
q
Plug shape: Monaural mini plug (ø 3.5)
w
Switch:
The platter rotates while the hot and cold
terminals are connected.
Use the non-lock type or lock type switch
you prefer.
• Operation of the main unit have priority over the operation of
remote terminal.
@5
Output terminal (PHONO OUT)
• Connect the included connecting cord here. (See page 8.)
@6
Ground terminal (SIGNAL GND)
• Connect the ground wire of the included connecting cord
here. (See page 8.)
@7
Power terminal (AC IN)
• Connect the connector side of the included AC cord here.
(See page 8.)
AC IN
REMOTE
PHONO OUT
GND
R
L
@5 @6
@4
@7
@3
Rear panel
3
ADJUSTMENTS
• Turn the power off when performing adjustments.
(1) Adjusting the tone arm height
1
q
Lower the lifer lever.
w
Set the stylus on the record and check that the
tone arm is virtually parallel to the record’s
surface.
2
If not:
q
Set the tone arm back on the arm rest.
w
Move the lock lever in the opposite direction of the
arrow to unlock.
e
Move the height adjustment dial and adjust the height
so that the arm is virtually parallel to the record’s
surface.
r
Move the lock lever in the direction of the arrow to
lock the height.
1
Set both the anti-skating knob to “0”.
2
Move the tone arm.
• Lift the tone arm from the arm rest and move it over
the platter.
✽
When moving the tone arm, be careful that the stylus
does not directly touch the platter or other parts.
✽
For cartridges with detachable stylus covers, adjust
with the stylus cover removed.
3
Adjust the horizontal balance.
• Move the counterweight forward or backward so that
the tone arm is parallel to the platter’s surface when
the tone arm is released.
✽
When adjusting the horizontal balance, be careful that
the stylus does not touch the slip mat or the main unit.
(2) Stylus pressure and anti-skating adjustment
B
Quartz
A
N
T
I-
S
K
ATING
7
6
5
4
32
10
ON
SLOW
BRAKE
OFF
POWER
START
/STOP
45
0
1
2
3
4
33
78
+12
0
-12
4
Set the tone arm back on the arm rest.
• Set the tone arm back on the arm rest.
230
115
230V
115V
