Denon DN-V300 - Professional DVD Player, Инструкции по последовательному управлению

Страница: 23 / 25

２３
Appendix 3 Stopping and Resuming Status of DVD
With the DN-V300, when playing a DVD, when the stop operation is performed or the stop command is
issued for the first time, the DN-V300 changes to the resume mode, and when the stop operation is
performed or the stop command is issued for a second time, the DN-V300 changes to the stop mode.
The response to serial remote commands according to the device’s status is defined as shown below.
The validity of commands depends on the device’s status, so be careful when controlling by serial
remote.
The DN-V300 is designed to issue the “PR StatusChange” message when a change of status occurs,
but the resume and stop modes are not distinguished, and both have the status code “3”.
To switch to the stop mode by serial control when playing a DVD, issue the “STOP” command two times
by PC RC command.
Example: To switch to the stop mode while playing a DVD
[PC,RC,49]<CR>
→
First stop message sent from the controller.
[PC,RC,0]
←
The sent message’s error code 0 (no error) is returned from the DN-V300.
[PR,StatusChange,3] ← The DN-V300 switches to the resume mode and a message is issued.
[PC,RC,49]<CR>
→
Second stop message sent from the controller.
[PC,RC,0] ← The sent message’s error code 0 (no error) is returned from the DN-V300.
The DN-V300 switches to the stop mode. (No message is issued.)
group command DVD STOP DVD RESUME
RC
PlayT
・OK→Title Play
・NG→Error code2
Error code1
PlayC
・OK
→Title&Chapter
PLAY
・ChapNG→Error code2
・TitleNG→Error code2
Error code1
Time
・OK→Time Play
・NG→Error code2
Error code1
SetAST Error code1 Error code1
SetSPST Error code1 Error code1
GetStatus Status ：3 Status3
GetDiscType Code：1 Code：1
GetAST Error code1 Memorized No.
GetSPST Error code1 Memorized No.
GetT Error code1 Memorized No.
GetC Error code1 Memorized No.
PC control
V300 response
PS
Same as IR remote controler
PC