10
Verticut T.T.
SP20007_REV_0
General Adjustments
6(77,1*)25+(,*+72)&87
Always stop the engine before adjusting the height
of cut. Failure to do this may result in serious injury.
The depth after cutting depends on the setting of
the front roller in relation to the main frame of the
machine.
7RVHW
6LPSO\URWDWHWKHNQREPDUOHG
‘A’
to raise and
lower the height of cut.
+$1'/(%$5$'-8670(17
The height of the Handle Bars can be adjusted to
suit various operators. Follow the below
instructions:-
1. Remove Bolt (Item 1) on both sides of the
machine.
2. Select the required position out of the 3
available.
3. Replace the Bolt on both sides of the machine.
GRASS BOX
If using the grass box, place the two locating tabs (projecting from the grass box support plates) into the slots on the
machine side plate. Lower the front of the box until the box support plates rest on the front cross bar of the machine.
Ensure both box support plates are properly located before proceeding.
Always disengage the cylinder drive before removing the grass box for emptying or access by reducing the engine revs
to tick over. Wait for the cutter to stop before removing.
$OZD\VNHHS¿QJHUVDZD\IURPWKHF\OLQGHUZKHQWKHHQJLQHLVUXQQLQJ6WRSWKHPDFKLQHEHIRUHPDNLQJDQ\
adjustments.
+ROGWKHJUDVVER[¿UPO\RQWKHOLSRIWKHDSHUWXUHDQGSODFHWKHRWKHUKDQGRQWKHIURQWHGJHRIWKHER[
A
,WHP
