THE SENSOSPHERE HAND GESTURES INTERFACE
The SensoSphere is controlled through a few simple hand gestures, shown here.
Note: the hand gesture interface is disabled when the
Proximity Sense
function is turned
Off in the SensoSphere App.
The SensoSphere has seven Colour Modes. To switch to the next therapy Mode, swipe your
hand twice (back and forth)
over the globe’s top, grazing within an inch of its pole. The dual
swipe should be made within 1 to 3 seconds, not too fast nor too slow. The selected therapy
Colour Mode can be identified by its initial colour:
Magenta
for Balancing
Turquoise
for Relaxing
Orange
for Energizing
Indigo-Blue
for Gamma
Green
for Evening
Amber
for Night Lite
Last Selected colour for Monochrome
Simultaneously place one hand over the globe’s top and the other
one over its equator, and hold for a couple of seconds. The
SensoSphere will blink to indicate it is now in Command mode.
Holding the first hand on the globe’s pole, slide your other hand by
a couple of inches along the equator: a clockwise shift will decrease
the light intensity while a counter-clockwise shift will increase it.
Don’t go too far on the decrease side
. Otherwise, you will switch Off
the SensoSphere
(see next section).
Once you’ve found the desired intensity, swiftly remove your hands
to release the Command mode. The SensoSphere will blink again to
confirm Command mode is released.
Therapy Colour Mode Selection
Light Intensity Control