12
Fender Assembly Instructions
Fish the three wires from the mainframe through the
1.
rear hole in the fender trough.
Route wiring in through back of tail light housing on the
2.
bottom inside of housing. Fish the three wire inside
of housing.
NOTE:
If fender is equipped with a front
marker light, lay wires in trough and route wires through
back of tail light housing with main frame wires (see red
arrow).
Pull all wire from light hole in housing and install the
3.
snapper hose clip approximately 1-1/2” back from end
of wire shielding. Squeeze snapper clip tight with pliers.
Push wires back into housing and finish routing wires in
4.
wire trough of fender and attach cable hanger. Install
two metal wire clips using pliers. Place one clip 5-1/2”
from rear of fender and one 8” from rear of fender (see
red arrow).
Install rubber grommet (with notch in grommet to the
5.
top) and attach 3 wire pigtail harness to fender wiring
(bullet connectors).
NOTE:
On the left side, plug in
the bullet plugs with white to white, black to brown and
yellow to red. On the right side, plug in bullet plugs with
white to white, black to brown and green to red.
If equipped with front marker light, attach wires using
6.
wire splicers, black to black or black to brown depend-
ing on which pigail harness and white to white onto the
3 wire pigtail harness. Coil pigtail harness inside of
fender housing and plug into 4” round light. Push light
into grommet with plug in to the top aligned with notch in
grommet.
Содержание Kar-Kaddy SS
Страница 1: ...1 6 17 RD20018 Rev 12...
