DeLuxe Stitcher M27 Series, Руководство по эксплуатации и обслуживанию

Страница: 20 / 44

18
The M27 Stitcher Machine can accommodate up to four (4) Stitcher Heads. The time may
come when additional Heads have to be added or removed from the stitcher. The following
are guidelines for mounting and removing both an 18D and a G20 Stitcher Head to or from the
M27.
To mount a Stitcher Head on the M27: Slip one (1) Bonnet Clamp Block (G20501 or 9002) into the
Lower Bonnet Rail (G30106) and one (1) into the Upper Bonnet Rail (G30107) of the M27 Stitcher,
approximately where the Head will be mounted. Align the Bonnet Clamp Eccentrics (G20524) or
Handles (18005A) in the Stitcher Head with the Blocks on the Machine, starting with the bottom of
the Stitcher Head. Tighten the Eccentric or Handle on the bottom slightly to hold the Head in posi-
tion.
While continuing to support the top of the Stitcher Head, align the Bender Slide with the Bender
Rail Assembly and tighten the Eccentric or Handle at the bottom of the Head a little more. Next line
the Driving Rail up with the Drive Rail Assembly and the Adjuster Block with the Adjuster Rail on
the Stitcher Machine. At this point, the top of the Head should slip over the Bonnet Clamp Block
in the Upper Bonnet Rail. Start to tighten the Eccentric or Handle at the top of the Head then com-
pletely tighten the Eccentric or Handle at the bottom. Completely tighten the Eccentric or Handle at
the Bottom of the Head and verify that the Head is mounted securely to the M27. The Clincher Plate
Assemblies can now be aligned with the Stitcher Head, see page 13 for more details.
To remove a Stitcher Head from the M27: While completely supporting the Stitcher Head, turn
the Bonnet Clamp Eccentrics or raise the Bonnet Clamp Handles until the Stitcher Head is released
from the M27. Lift the Head off the Bonnet Clamp Blocks then remove the Blocks from the Bonnet
Rails.
Mounting & Removing Heads