DeLuxe Stitcher M27 Series, Руководство по эксплуатации и обслуживанию

Страница: 16 / 44

14
not be aligned with the Stitcher Head’s Driver.
Refer to both
Figure 7 and Figure 8
and the
following instructions for directions on center-
ing the Clincher Points.
Loosen the two (2) Screws (UA3310.3 or
9081B) securing the Clincher Plate to the
Retaining Plate in the M27’s Clincher Rail.
With wire threaded through the machine and
the compression set to 1/8” turn the machine
over manually, but stop as the staple begins to
exit the Bender Bar. Move the Clincher Plate
Assembly from side to side, until the Driver is
centered above the Clincher Points. The legs
of the staple should line up with the Clincher
Points.
Although the front-to-back alignment is set at
the factory, it can be adjusted one of two ways.
For large adjustment, loosen the two (2) Screws
(G30159) securing the Clincher Rail (G30132)
to the M27 Frame. Using the same half-formed
stitch for centering the Clincher Points, line the
legs of the staple up with the Clincher Points
from back to front. Tighten the Screws to secure the Clincher Rail in this position. Re-check the
side-to-side adjustment after completing the front-to-back
adjustments and then tighten the two (2) screws securing the Clincher Plate to the Retaining Plate
in the Stitcher’s Clincher Rail. Complete the machine’s cycle and remove the formed staple so as to
not jam the Clincher Points. For fine adjustments, refer to the Stitcher Head’s Operation Manual.
Specifically, refer to the section of the manual which highlights making adjustments to the Leveling
Screws on the back of the Stitcher Head.
Figure 8 - Centering the Clincher Points
UA3310.3 or
9081B
18186