13
USB PORTS
There are two (2) USB ports contained in your Vehicle Jump Starter &
Portable Inflator.
1) Type – C USB, (IN) port – 5V, 2Amp for charging the internal battery
contained inside the Jump Starter & Portable Inflator.
2) Type USB (OUT), 5A, 2.1Amp.
LED FLASHLIGHT
1) To turn the LED lights ON simply hold the ON/OFF Button down for at least
two (2) seconds.
2) To turn the LED lights OFF hold the ON/OFF Button down for at least two
(2) seconds.
USER MAINTENANCE INSTRUCTIONS
1) The battery level should be checked, and the Vehicle Jump Starter &
Portable Inflator should be charged every three (3) months. Keeping the
internal battery fully charged will ensure the Vehicle Jump Starter &
Portable Inflator in ready to use when needed. This will also extend the life
of the internal battery.
2) Store the Vehicle Jump Starter & Portable Inflator in a clean dry
environment at room temperature if possible.
3) If you see a bulge in the case or notice a chemical smell STOP using the
Vehicle Jump Starter & Portable Inflator immediately and seek technical
help.
14
TROUBLE SHOOTING
FCC WARNING
PROBLEM SOLUTION
The vehicle will not start
Check the connection of the alligator
clips to the battery terminals and
ensure the LED is solid green and not
flashing on the smart alligator clips.
Ensure you have a minimum of 50%
value for the internal battery.
Vehicle Jump Pack & Portable Inflator
will not charge
Check the cable and connection and try
charging a different device.
Title 47 Subpart, 15.105(b)
Note: This equipment has been tested and found to comply with the limits for a
class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in
residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio television reception, which
can be determined by tuning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.