11
3) Press the
“Inflator Mode”
button and the LCD will change to the
Inflator Mode Screen.
4) See below.
5) The default setting is 36.0 PSI. To change from PSI/BAR/KPA simply press
the
“Inflator mode”
button
with a single press.
6) To adjust the automatic cut off pressure setting, press either the
+ or –
button
to adjust the value up or down.
7) Connect inflator hose to valve stem.
8) To Start/Stop the inflator press the
“Inflator Start/Stop”
button
.
9) The inflator will shut off at the preset pressure.
12
CAUTION
CAUTION
1) The inflation air pressure of balloons, balls, swimming rings/floats and other
products is less than the range of the air pump, and the inflation cannot be
automatically stopped at the preset air pressure. Please be careful when
using it under these conditions.
2) Always check the required air pressure and the maximum air pressure
when inflating any tires.
CHARGING THE VEHICLE JUMP STARTER & PORTABLE INFLATOR
1) Use the supplied USB cable to charge the Vehicle Jump Starter & Portable
Inflator.
NOTE:
While charging none of the other features and functions are
active.
2) Once the internal battery level has reached 100% the charge is complete,
and the unit will turn off after 10 seconds.
3) The battery level should be checked and charged every three (3) months.
4) When charging the internal battery, work in a well-ventilated area and do
not restrict ventilation in any way.
1) The device shall be stored indoors and protected from the elements.
2) The unit shall not be charged outdoors.
3) When in use, steps should be taken to reduce the exposure to rain, sleet,
snow, and the like.