INSTRUCTIONS PW150/PW200
10
Figure 23
Figure 24
Figure 25
Figure 26
Figure 27
Figure 28
Figure 29
10). Clamp and fix the motor front plate on the door temporarily.
11). Lift up the motor and insert the screws into the front plate.
12). Lift the motor overhead and push the gate to the end until the screw holes of the motor end matches the holes
on the rear plate. Fasten the motor to the rear plate with the bolt as shown in
Figure24
.
13). Fasten the nut tightly and loosen it for half round for motor supporting in rotating.
14). Fasten the motor front end to the front plate with the bolt and nut tightly. Fully tighten the screw.
15). Use appropriate release key to release the gear motor.
16). Try to push the released gate and make sure the motor can be manually moved easily.
17). Make sure the motor front plate can be fastened on the gate to be installed permanently.
18). Use the appropriate release key to fasten the gear motor again.
19). Loosen the plastic nut under the power cable of the motor end, and penetrate the power cable through the nut
and screw it up.
20). Connect the motor power cable as shown in
Figure 26
.
A
B
21). Close the gear motor cover by tightening the two screws as shown in
Figure27
.
22. Gear Motor Release
1) Remove the rubber plug and insert the release key. See
Figure 28
2) Turn the key anti-clockwise and pull the handle out. See
Figure 29
White(+)
Yellow(-)
Red(5V)
Green(Signal)
Black(GND)
Motor
Hall Sensor
Hall Sensor
Hall Sensor
Содержание PL1000
Страница 2: ......
